STARTING PROCEDURE OF AUXILLARY ENGINE

STARTING PROCEDURE OF AUXILLARY ENGINE
SL.NO	Description	Yes/No/Na
	LOCAL STARTING
1	Open the starting air v/v, control air v/v, indicator cock and blow through.
2	Check the line for F.O., cooling water and L.O.
3	Set the operating lever to "START" position.
4	Press the push button for the starting operation v/v.
5	If the rotation speed of the engine has rapidly increased
	and starting has been established along with continous ignition sound, release the
	push button.
6	After conforming that the rotational speed of the engine has reached the
	specified speed and each pressure has reached the specified value, set the
	operating lever to "RUN" position.
	oil.
	REMOTE STARTING
1	switch the starting mode to the remote mode from local mode.
2	Set the operating lever to "RUN" position.
3	Open starting airv/v, control air v/v, after conforming that "READY" indication lamp
	has lit up in E.C.R. panel.
4	Press the starting push button.
5	Confirm that "RUN" indicator lamp on the panel has lit up as the rotation speed of
	the engine has reached the specified rate, and each pressure has reached the
	specified value.
6	Close the starting air v/v
	STOPPING
1	Incase of heavy fuel oil is used, switch the fuel oil to D.O. 30 minutes before
	stopping the engine.
2	Confirn L.O. priming pump is on "AUTO" mode.
	LOCAL POSITION
1	Shift the operating lever to "STOP" position.
	REMOTE STOPPING
1	Press the "STOP" push button on the control panel & then press "ENTER" push
	button on control panel.
2	Open the indicator v/v, once engine stops, conduct air running for 3 to 4 sec &
	exhaust the combustion gas out of the combustion chamber. Then close the indicator v/v.